How can I set the receiver to auto satellite selection mode, so it selects the proper Satellite frequency?
- Go to the RDI (Remote Diagnostic Screen)
Figure 1 Main Screen.
- Press the Right key until you reach: Configuration (see figure 2).
Figure 2 Configuration Screen
- Press the Down key to Enter. Press the Right key until you reach: DGPS Config (see figure 3).
Figure 3 DGPS Config Screen
- Press the Down key until you reach: EZ Sat: Omni* Mode (see figure 4).
Figure 4 Frequency selection Screen
- Press the Right key first letter starts blinking. Press the Down key until you Auto (see figure 5). To store the selection press ENTER ¿.
- If the receiver has not yet downloaded the latest Satellite table. Then first manually select an Omnistar satellite in view. (E.G. AFSAT for Europe). The satellite table is send one time per hour. So after one hour one can select Auto mode.
Figure 5 Auto mode
- After a while (when an antenna is connected) you will see the frequency selected by the receiver. In this case the AF-SAT (see figure 6)
Figure 6 Freq automatically selected, in this case AF-SAT